Honeywell HW2CESAWW9 User Manual page 15

Portable air conditioner
Table of Contents

Advertisement

Available languages

Available languages

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TEMPERATURE CONTROLS
Used for adjusting the thermostat.
The default display is room temperature.
In cooling mode, when + or - button is pressed, the set temperature is displayed and may be
adjusted. After a few seconds the display will revert back to room temperature. Temperature is
only adjustable in cool or heating mode.
Note: By pressing both + or - buttons at the same time, the display will toggle between Fahrenheit (°F)
and Celsius (°C).
MODE CONTROL
Settings: Air Conditioning, Dehumidifying, Fan, Heating*.
The corresponding indicator light will illuminate to indicate the current mode setting.
Air Conditioning Mode (COOL)
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 61°F - 89°F (16°C - 32°C).
Dehumidifying Mode (DRY)
Air is dehumidified as it passes through the unit, without being in full cooling mode.
If room temperature is higher than 77°F (25°C) fan speed can be adjusted; otherwise fan speed is
preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose.
Continuous drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
Fan Mode
For air circulation without air conditioner cooling.
Heating Mode*
When heating mode is selected the indicator light will illuminate. Heating is activated when the
ambient temperature is between 44°F - 77°F (7°C - 25°C). In this mode, the desired temperature
can be set between 61°F - 77°F (16°C - 25°C).
Note: The exhaust hose must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the internal
water tank. The unit will pause operation when the tank is full and will restart when the tank has
been emptied. It is recommended to use the Heating Mode in a room with 50% humidity or lower.
Avoid operating moisture-producing products or appliances such as a humidifier or a kettle when
using the unit in Heating Mode. See the "Draining Water Condensation in Heat Mode" section for
more information on draining the water tank.
*Applicable for models with Heating feature only.
EN
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hw2hesaww9

Table of Contents