TANDBERG Media Processing System MPS 200 Administrator's Manual page 142

Conference Template
Network Settings
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the Create Conference
Bandwidth Management
Manual:
Disables automatic regulations of sites to Low rate encoder,
based on video rate reports.
Auto:
Enables automatic regulations of sites to Low rate encoder,
based on video rate reports
Network Error Handling
None:
Set to None to not enable error handling.
IPLR:
Set to IPLR (Intelligent Packet Loss Recovery) if one or more
sites are experiencing network errors.
FURBlock:
Set to FURBlock (Fast Update Request Block) if one or
more sites are experiencing network errors.
The Network Error Handling may be set to IPLR (Intelligent Packet
Loss Recovery) or FURBlock (Fast Update Request Block) if one or
more sites are experiencing network errors.
IPLR Robust Mode
Auto:
When set to Auto, the IPLR Robust Mode is turned on for each
encoder when needed.
On: When set to On, the IPLR Robust Mode is on for all encoders.
Please refer to Intelligent Packet Loss Recovery (IPLRTF)
cal Description section.
Table of
Main Introduction
Contents
D 13373.08
NOVEMBER 2007
in the Overview section.
in the Techni-
Quick
Installation
Setup
Conference Template Configuration
Network
If a conference participant is experiencing poor network quality it will send Fast Update Requests (FUR) to the
encoder in the MCU to make it refresh the picture. This can be observed as a short flash in the picture.
Poor network conditions for one participant may have a deteriorating effect on the video quality for some of
the participants in the conference.
In an effort to reduce this effect the Network Error Handling can be used.
FUR Block Sites
Auto:
When set to Auto, the FUR's from
sites that send too many will be blocked.
On: When set to On, the FUR's from all
sites will be blocked.
Using System
the MPS Status Configuration
142
Press
FUR Filter Interval
Denotes the number of seconds between
FUR's, e.g. the minimum time between
FUR's that will refresh the picture.
MCU
System Gateway
Configuration
Configuration
TANDBERG MPS
ADMINISTRATOR GUIDE
Save to activate the new settings
Technical
Appendices
Descriptions
MPS