Time Display Brightness; Aux Input Sensitivity - T+A CD Player K1 AV User Manual

AUX MIN
Amplifier Setup Menu point
Explanation:
The brightness of the clock display can be adjusted (dimmed) through eight stages (1 to
8).
'DIMMER 1' (= darkest stage)
to
'DIMMER 8' (= brightest stage)
This facility enables you to set the screen brightness to suit the lighting conditions in the
machine's particular location in your listening room.
Operation:
The screen displays the current brightness stage (e.g.: 3):
'DIMMER 3'
You can change the current setting by briefly pressing the remote control buttons  or
.

The brightness value selected here is only used when the clock is displayed.
Amplifier Setup Menu point
Explanation:
Auxiliary equipment connected to the AUX input may generate an output at a different
level. This will produce a disturbing volume difference when you switch source devices.
the sensitivity of the AUX input can be adjusted in four stages to overcome the problem of
quiet auxiliary equipment:
'AUX MIN'
'AUX LOW'
'AUX MED'
'AUX MAX'
The volume control responds analogously, i.e. at 'MIN' it is quietest, and at 'MAX' it is
loudest.
 To avoid overload distortion, the AUX input should always be set to the lowest
sensitivity ('MIN') when you first connect a high-level device to the machine.
Operation:
The screen shows the current setting, e.g.: 'AUX
The current setting can be changed using the  or  buttons on the remote control
handset; every change takes effect immediately. The menu closes when you press the
 button.
If the menu control buttons (, , , ,  or ) are not operated for a
period of about ten seconds, the amplifier interrupts the menu (Timeout) and reverts to the
normal screen display.
Brightness of the time display

AUX input sensitivity

40
(CLOCK)
MIN'