Advertisement
1. Place top ① face down on protected flat surface so
that the threaded inserts are facing up.
2. Align leg plates ③ (attached to legs ②) with
threaded inserts in the top ①.
Using a 4mm Allen wrench or 4mm hex bit, secure
top with 1/4"-20x19mm joint connector bolts. DO NOT
FULLY TIGHTEN until Step 6.
②
③
3. Remove the #12 star lock washers and M6-1x10mm
screws located in the legs ②.
②
Align holes in cross bar ④ with pilot holes in legs ②.
Attach using #12 star lock washers and M6-1x10mm
screws. The bar should rest inside the legs. DO NOT
FULLY TIGHTEN until Step 6.
If you have an adjustable cross bar, use #12 star lock
washers and M6-1x14mm screws to fasten the two
connector bars together. DO NOT FULLY TIGHTEN
until Step 6.
wibenchmfg.com
①
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
ASSEMBLY
4. If assembling a desk or table with a foot rest bar,
repeat Step 3 with the foot rest bar on the lower
portion of the legs.
5. If assembling a table/workstation with metal wire
management, align pre-drilled holes in metal wire
management with pilot holes in the top.
Attach wire management to top using #8x3/4" screws
and a Phillips screwdriver. Fasten down tightly.
6. Fully tighten legs ②, connector bar ④ & foot rest
(if foot rest was ordered) with fasteners. Adjust leg
height and glides as needed.
7. If assembling a table/workstation with grommet(s),
insert grommet(s) into the pre-determined location in
the top.
8. If optional footing was ordered, remove nylon glide
⑤ from leg by rotating it counterclockwise until glide
is free.
Place stem of optional footing into the hole on the
leg. Rotate clockwise until fully inserted into leg.
Tighten with a 14mm open-ended wrench (for dual
wheel caster only).
Repeat for each caster/glide.
⑤
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
3
Advertisement
