Husqvarna BMS 150 Operator's Manual page 15

To install the wheel weights
1. Install the 5 weights (A) in the wheel (B).
A
C
®
2. Apply LOCTITE 243 to the 4 screws (C).
3. Install the 4 screws (C).
4. install the wheel on the product.
D
®
5. Apply LOCTITE 243 to the 5 screws (D).
6. Install the 5 screws (D).
To replace the blade
WARNING:
blades are very sharp.
WARNING:
cannot start when you replace the blade.
1. Use the tool angle control to lift the tool holder from
the floor.
1817 - 002 - 13.04.2022
B
Use protective gloves. The
Make sure that the product
2. Loosen the screws on the tool holder.
3. Remove the blade.
4. Push the new blade into the tool holder.
5. Make sure that the blade is in the correct position.
6. Tighten the screws on the tool holder.
To install a chisel
WARNING:
blades are very sharp.
WARNING:
cannot start when you replace the blade.
1. Remove the blade. Refer to
page 15 .
2. Put the chisel (A) on the tool holder (B).
A
B
C
3. Install the washers and screws (C).
To sharpen the blade
WARNING:
blades are very sharp.
Use protective gloves. The
Make sure that the product
To replace the blade on
Use protective gloves. The
15