Transmitting Data - Suunto D9 User Manual

5.8.3. Transmitting data

After the pairing procedure, the Suunto D9 will receive cylinder pressure data from
the transmitter. The pressure is displayed in either bars or psi, depending on the unit
selected. Any time the Suunto D9 receives an appropriate signal it flashes the lightning
figure in the display's lower left corner. A pressure reading of over 360 bar/5220 psi
will display as "---".
If the Suunto D9 is unable to receive a valid signal for more than one minute it will
start displaying "FAIL" intermittently with the latest valid pressure reading.
If the transmitter battery is running low, a low battery warning "LOB" will be transmitted
and displayed intermittently with the pressure reading.
If the dive is started without the Suunto D9 and the transmitter having been properly
paired, the dive computer will indicate that no cylinder data is available by displaying
"OFF".
Table 5.4. Pressure transmission related displays
Display Indication
Set Code. No code stored, Suunto D9 ready for pairing with
Cd:--
transmitter.
Pressure reading over 360 bar/5220 psi
- - -
Indicates pressure reading has not been updated for more than
FAIL
one minute. Transmitter is out of range, in power saving mode or
on another channel. Activate the transmitter by breathing off the
regulator, and recode the wrist unit if necessary.
44
Figure
A
B
C