Water Resistance Inspection - Suunto D9 User Manual

IMPORTANT: Your Suunto D9 should be soaked, then thoroughly rinsed with fresh
water and dried with a soft towel after each dive. Make sure that all salt crystals and
sand particles have been flushed out. Check the display for possible moisture or water,
and do not use the Suunto D9 if you detect any moisture or water inside.
CAUTION

8.4. Water resistance inspection

The water resistance of the unit must be checked after replacing the battery or after
other service operations. The check requires special equipment and training.
You must frequently check the display for any sign of leaks. If you find moisture inside
your dive computer, there is a leak. A leak must be corrected without delay, as moisture
will seriously damage the unit, even beyond repair. Suunto does not take any
responsibility for damage caused by moisture in the dive computer, if the instructions
of this manual have not been carefully followed.
In the event of a leak, immediately take the dive computer to an authorized Suunto
representative.
94
•
Do not use compressed air to blow water off the unit.
•
Do not use solvents or other cleaning fluids that might cause
damage.
• Do not test or use the dive computer in pressurized air.