Table of Contents
Advertisement
Ensure that the Suunto HelO
2.
in the Suunto HelO
The HelO
should display "cd:--" in the lower left corner of the alternative display.
2
3.
Slowly open the cylinder valve fully and pressurize the regulator. The transmitter starts
transmitting when the pressure exceeds 15 bar/218 psi.
Take the Suunto HelO
4.
display the selected code number and then start displaying the transmitted cylinder
pressure. The wireless transmitter indicator is displayed every time the Suunto receives
a valid signal.
WARNING
NOTE
5.8.3. Transmitting data
After the pairing procedure, the Suunto HelO
transmitter. The pressure is displayed in either bars or psi, depending on the unit selected.
Any time the Suunto HelO
indicator in the display's lower left corner.
Table 5.3. Pressure transmission related displays
Display
Indication
Set Code. No code stored, Suunto HelO
Cd:--
mitter.
Pressure reading over 360 bar/5220 psi.
- - -
Pressure reading has not been updated for more than one minute.
FAIL
The latest valid pressure reading is displayed intermittently. After five
minutes, "FAIL" is displayed intermittently with "---".
Transmitter is out of range, in power saving mode or on another
channel. Activate the transmitter by breathing off the regulator, and
recode the wrist unit if necessary.
Pressure transmitter battery voltage is low. The pressure reading is
LOb
displayed intermittently. Change the transmitter battery!
OFF
Pairing has not been conducted between the dive computer and the
transmitter before start of dive. No cylinder data available.
18
is turned on, and that the wireless integration is enabled
2
settings (HP set ON, see Section 5.9.8. Setting the HP code).
2
wrist unit close to the transmitter. The unit will then quickly
2
If there are several divers using Suunto HelO
sion, always ensure that each diver is using a different code before
starting the dive.
You can manually change the transmitter's code by reducing the
pressure to less than 10 bar/145 psi and then immediately (within 10-
12 seconds) increasing the pressure to above 15 bar/220 psi.
Reset the transmitter's code manually, see Section 5.9.8. Setting the
HP code.
The transmitter will then select a new code. The Suunto HelO
be in "cd:--" mode to pair on the new code. This procedure can be
used if, for example, your dive buddy has the same code and you
need to change it.
In order to save battery energy, the transmitter shuts off if the pressure
remains unchanged for more than 10 minutes, and it will continue
transmitting with the saved code when any pressure change is
measured.
receives an appropriate signal it flashes the wireless transmitter
2
will receive cylinder pressure data from the
2
ready for pairing with trans-
2
with wireless transmis-
2
2
Figure
A
B
C
D
E
must
Advertisement
Table of Contents
