Cleanload Nexus Plumbing Layout - Pentair HYPRO CLEANLOAD NEXUS Installation And Operation Manual

5.2 Cleanload Nexus Plumbing Layout

It is easiest to use Cleanload Nexus with sprayers that are already
fitted with an induction bowl and inductor (venturi). In this case,
a Tee fitting and a check valve (not included) should be fitted to
divert the suction line to the Cleanload Nexus as shown below.
11
1 Container fitted with easyconnect cap
2 Rinse water source
3 Cleanload Nexus
4 Calibrated Suction Hose
5 Check valve
6 Check valve
7 Tee
NOTE: Flow from the coupler to the check valve should only be
downwards. If the venturi is located below the level of the Cleanload
Nexus, the check valve may be fitted close to the venturi.
OR
If the venturi is located above the level Cleanload Nexus the check
valve should be fitted into a part of the Suction Hose that is below
the Coupler.
if the Cleanload Nexus is mounted on the sprayer the Suction Hose
and the Rinse Water Supply Hose can be permanently plumbed into
the sprayer.
8
13
12
10
6
9
7
8
CAUTION
!
it must not be possible to shut off the suction line to Cleanload
Nexus while in use.
4
5
8 Sprayer induction area
9 Shut off valve
10 Induction bowl
11 Circulation line from sprayer pump
12 Inductor (venturi)
13 To sprayer tank (without restriction)
If it is not mounted on the sprayer it may be connected temporarily
during filling using suitable dry break connectors (not included).
For specific instructions on suitable connections for the sprayer
please refer to instructions provided by the sprayer manufacturer.
The connection of Cleanload Nexus must be done
WARNING
!
by professionals who are trained in repair and maintenance of the
sprayer.
If Cleanload Nexus is not mounted correctly, it may
WARNING
!
result in malfunctioning, spillage of agrochemical and contamina-
tion of the operator and/or environment.
CLEANLOAD NEXUS PNR-CN100-OIPM (10/12/21) ©2021 Pentair. All Rights.
When connecting Cleanload Nexus to a sprayer,
3
1
2