LG MVEM1825 Series Installation Manual page 13

us_main.book.book Page 13 Wednesday, May 4, 2022 1:09 PM
2
Drill holes at points A and B. Drill the third
hole inside area C, through one of the bottom
holes to match the location of a stud. If there
is a stud, drill a 3/16 hole for lag screws. If
there is no stud, drill a 5/8 hole for toggle
bolts. These holes must be used for
mounting. If the holes are not used, the
installation will not be secure. The installer
must use these holes for proper installation.
Use toggle bolts through these holes, unless
one of them lines up with a stud. Use a lag
screw for studs. Make sure to use at least 1
lag screw in a stud, and 2 toggle bolts in the
drywall or the plaster.
A
A
Minimum 66" from the floor
a
For wall - venting only
b
Draw lines on studs
c
Draw center Line
d
Mounting plate
e
Support tab
f
NOTE
• Cut out the shaded area marked F on the rear
wall template for wall-venting.
3
Remove the template from the rear wall.
4
Attach the plate to the wall
toggle head bolts
d
wings from the bolts. Insert the bolts into
c
the mounting plate
a
toggle head to 3/4 of the length past the bolt
ends. Insert the spring toggle head into the
holes in the wall to mount the plate. You may
pull forward on the plate to help in tightening
the toggle bolts. Tighten all bolts.
B
B
C
. To use spring
e
: Remove the toggle
and replace the spring
Space more than wall thickness
b
Bolt end
f
Step 6: Attach the Oven to the Wall
WARNING
• To avoid risk of personal injury or property
damage, you will need two people to install this
microwave oven.
1
Carefully lift the microwave oven and hang it
on the support tabs at the bottom of the
mounting plate. Reaching through the upper
cabinet, thread the power supply cord
through the power supply cord hole
bottom of the upper cabinet.
2
Rotate the microwave oven upward so the top
of the oven is against the bottom of the upper
cabinet or cabinet frame.
3
Then insert a bolt down through each hole
in the upper cabinet bottom. Tighten the bolts
until the gap between the upper cabinet and
microwave oven is closed.
4
Roof venting installation: Install the ductwork
through the vent opening in the upper
INSTALLATION 13
a
in the
b
a