LG MVEM1825 Series Installation Manual page 10

us_main.book.book Page 10 Wednesday, May 4, 2022 1:09 PM
10 INSTALLATION
3
Use side cutters or tin snips to cut out and
remove the knockouts
. Be careful not to distort the back plate.
a
Discard the knockouts.
4
To avoid pinching the blower wire, make sure
that it is channeled underneath and between
the two exhaust ports when they are rotated.
5
Rotate and reinstall the blower unit
the exhaust ports
b
cabinet and are aligned with the rear
knockouts. When you insert the blower unit,
the blower wire must be routed as shown.
c
6
Attach the blower plate
oven so the blower unit exhaust ports
blower plate opening are aligned. Attach one
or two blower unit mounting screw(s)
then one or several blower plate mounting
screw(s) .
a
from the back plate
b
so that
a
face the rear of the
to the microwave
d
and
c
and
f
Blower unit
b
Back plate
e
7
Insert the tabs on each side of the damper
into the holes at the inside rear of the
adapter. Attach the exhaust adapter
back plate wall side. Push in securely until it is
past the top locking tabs
locking tabs . Make sure that the damper
c
hinge is at the top and that the damper
swings freely.
Damper (hinge side up)
b
Guides
c
Slide exhaust adapter into guides on rear
e
panel.
Roof-Venting Installation
1
Follow steps 1 and 2 under Wall-Venting
Installation.
2
Rotate and reinstall the blower unit
the exhaust ports face the top of the
b
cabinet. When you insert the blower unit, the
blower wire must be routed as shown.
c
to the
a
and in the lower
c
so that
a