Power Requirements - Sundance Spas CAMDEN 780 Owner's Manual

• PROPER dRAINAGE:
measures to sufficiently handle excessive water spillage. Be
sure the flooring in which the spa rests on has adequate drainage
and can handle draining of the entire contents of the spa. Be sure
to make provisions for ceilings or any other structures that may be
below the spas installation. Areas around your spa can become wet
or moist so all flooring and subsequent furniture, walls and adjacent
structures should be able to withstand or resist water and moisture.
• PROPER vENTILATION:
with an Engineer or authority competent enough to understand
the necessary provisions needed to vent moist or heated air and
air associated with chemical odors outdoors. When the spa is in
use considerable amounts of moisture will escape potentially causing
mold and mildew, over time this can damage certain surfaces and or
surroundings.
• SUFFICIENT ACCESS:
need to access or gain entry to any portion of the spa for servicing,
it is highly recommended that you plan your indoor installation to
provide full access to the entire spa.
• WARRANTY:
or any improper installation not in accordance with local codes or
authorities is not covered under the spas warranty. Please consult
your local state or city building ordinances.
5.0

Power Requirements

®
Sundance spas are designed to provide optimum
performance and flexibility of use when connected to the
maximum electrical service listed on pages 12-14. If you
prefer, your qualified technician can perform a minor circuit
board modification to allow your spa to accept an electrical service other
than the factory setting.
Note: Refer to pages 44-49 for circuit board configuration details or
contact your authorized Sundance dealer.
It is extremely important to have in place
Proper ventilation should be discussed
In the unlikely event that you should ever
Damage caused by not following these guidelines
780 SERIES
Page 11