Milwaukee 2830-20 Operator's Manual
  1. Manuals
  2. Brands
  3. Milwaukee Manuals
  4. Saw
  5. 2830-20
  6. Operator's manual

Milwaukee 2830-20 Operator's Manual

M18 fuel 7-1/4" rear handle circular saw
Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
Cat. No. / No de cat.
2830-20
M18 FUEL™ 7-1/4" REAR HANDLE CIRCULAR SAW
SCIE CIRCULAIRE À POIGNÉE ARRIÈRE 184 mm (7-1/4")
M18 FUEL ™
SIERRA CIRCULAR DE MANGO TRASERO 184 mm (7-1/4")
DE M18 FUEL ™
WARNING
AVERTISSEMENT
comprendre le manuel.
ADVERTENCIA
To reduce the risk of injury, user must read and understand operator's manual.
Afin de réduire le risque de blessures, l'utilisateur doit lire et bien
Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2830-20 and is the answer not in the manual?

Questions and answers

Related Manuals for Milwaukee 2830-20

Summary of Contents for Milwaukee 2830-20

  • Page 1 OPERATOR'S MANUAL MANUEL de L'UTILISATEUR MANUAL del OPERADOR Cat. No. / No de cat. 2830-20 M18 FUEL™ 7-1/4" REAR HANDLE CIRCULAR SAW SCIE CIRCULAIRE À POIGNÉE ARRIÈRE 184 mm (7-1/4") M18 FUEL ™ SIERRA CIRCULAR DE MANGO TRASERO 184 mm (7-1/4") DE M18 FUEL ™...
  • Page 2 Do not use this tool if you do not understand these operating instructions or you feel the work is beyond your capability; contact Milwaukee Tool or a trained professional for additional information or training. • Maintain labels and nameplates. These carry important information.
  • Page 3 1. • If the guard still does not immediately spring back into place, contact a MILWAUKEE service facility for repairs. Installing Blade 1. Remove from battery pack 2.
  • Page 4 OPERATION Adjusting Depth 1. Remove from battery pack To reduce the risk of injury, always WARNING 2. To adjust depth of cut, place saw on edge of work- wear proper eye protection marked bench and pull up depth adjusting lever. to comply with ANSI Z87.1.
  • Page 5 Tighten depth and miter adjusting levers Grip saw with securely both hands, keeping hands Set depth of cut away from 1/8"-1/4" greater than blade thickness of stock Rest saw on larger Wear safety part of workpiece, goggles allowing smaller part to fall away 1/8"...

Table of Contents