Table of Contents
Advertisement
Release Paddle To Launch
NOTE:
The TransBrake™ feature provides the fastest
method of launching the car which results in the
lowest 1/4 mile ET.
D
M
O
RAG
ODE
PERATIONS
1. Enable DRAG Mode — A quick double press of
the "SRT" button is a shortcut to enable DRAG
mode. DRAG mode can also be accessed
through the radio.
2. Line Lock — Warm the tires by using Line Lock
(burnout).
Initial Conditions:
a) Vehicle speed must be 0 mph (0 km/h).
b) Engine speed greater than 500 RPM.
c) Radiator coolant temp less than 250°F
(121°C).
d) Odometer greater than 500 miles
(805 kilometers).
e) Cruise Control, Launch Mode,
Trans-Brake and Valet Mode are disen-
gaged.
f)
All doors closed.
• Instructions for Line Lock (burnout) are
displayed in instrument cluster display, and
listed below.
a. Press the brake pedal to hold the car still
while transmission is in DRIVE.
b. Select "Line Lock" feature though the touch
screen radio.
c. Press and hold the OK button on the
steering wheel to activate "Line Lock".
d. While still holding down the OK button, fully
release the brake pedal and apply the gas
pedal to begin the burnout.
Front brakes remain engaged.
Feature is exited when either the gas pedal
is lifted, the brake pedal is pressed, the
OK button is released, or the max number of
tire revolutions is attained.
GETTING TO KNOW YOUR INSTRUMENT PANEL
3. TransBrake™ Launch
Initial Conditions:
a) Odometer greater than 500 miles
(805 kilometers).
b) Vehicle must have Drag mode enabled.
c) Engine is running.
d) Vehicle speed is at 0 mph (0 km/h).
e) Steering wheel is straight.
f)
Vehicle is in "DRIVE" in 1st gear.
g) Radiator coolant temp is less than
250°F (121°C).
h) Line Lock/Launch Control and Cruise
Control are not engaged.
i)
All doors are closed.
j)
Parking brake is not set.
k) Vehicle is on level ground.
17
3
Advertisement
Table of Contents
