Drying - Siemens WT46W564BY Operating And Installation Instructions

Table of Contents

Advertisement

specting the
dryer
nnecting the
mains plug
oading laundry
woollens"
he programme
1
drying programme ...
2
idual requirements
sitive and only need to
3
Start/Pause button
with the fluff filter
asing phase after the
one of two levels.
for a longer drying time;
ilk.
ady.
Page 4.
e container
Page 9.
Do not pull out/empty
the condensate container when drying is in progress

Drying

Condensate container with filter
Drum interior
Control panel
light
Drum
Two-part
fluff filter
Air inlet
Drying
Emptying condensation
Empty the container after each drying cycle, not during drying!
1.
Remove the condensate container and hold it level.
Pour out the condensation.
2.
3.
Always push the container fully back in until it locks in place.
If the
Container indicator lamp is flashing
Cleaning the fluff filter
Clean fluff filters reduce energy consumption.
The fluff filter consists of two parts. Clean the inner
and outer filter after every drying cycle:
1.
Open the door. Remove fluff from the door/door area.
2.
Pull out both parts of the fluff filter.
3.
Remove fluff from the edge of the shaft. Fluff should not fall
into the open shaft.
4.
Open the filter and remove all the fluff.
5.
Rinse both parts under running water and dry thoroughly.
6.
Close the inner and outer filter, put them back together
and reinsert them into the appliance.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
Your dryer is equipped with an automatic anti-crease function. The drum is moved at specific time intervals
for 30 minutes once the programme has ended. The laundry stays loose and fluffy (60 or 120 minutes if
the additional
(Less Ironing) function is selected).
The programme has ended
Interrupt programme
removing or adding laundry.
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The selected programme must then be continued until it is finished.
Never switch the dryer off before the drying process has ended.
1.
Open the door. The drying cycle is interrupted.
2.
Remove or add laundry and close the door.
3.
If required, select a new programme and additional functions.
4.
Press the
Start/Pause button. The remaining time is updated after a few minutes
3
page 9.
when
lights up in the display panel.
4
4

Advertisement

Table of Contents
loading

Table of Contents