Table of Contents
Advertisement
POWER INPUT WIRING
SPEAKER/SUBWOOFER WIRING
Speaker have a positive and negative marking on the terminals. These are used to indicate polarity and must be
considered when wiring speakers or subwoofers to an amplifier. Amplifiers also have positive and negative
markings on their speaker outputs. Use these marking to match polarities to ensure the speakers are in phase.
Failure to wire speakers or woofers in phase with one another will result in a loss of bass. The MXA600.6 require
a minimum 2 impedance in stereo or 4 ohms in mono (bridged) mode.
Always check your speaker load with a multi-meter before hooking them up to the amplifier. Any
Impedance (load) smaller than what is recommended will damage the amplifier! Such damage is not
covered under warranty, so pay strict attention to what connections are made to the amplifier.
2
2
5/6 CHANNEL
2
2
2
2
3/4 CHANNEL
1/2 CHANNEL
Chassis
Ground
( - )
BRIDGED 4
BRIDGED 4
Remote Turn On
Fuse Holder
BATTERY
Near Battery
BRIDGED 4
Advertisement
Table of Contents
