Integration Instructions; General; List Of Applicable Rules; Specific Operational Use Conditions - Elatec TWN4 MULTITECH NANO M Integration Manual

3 INTEGRATION INSTRUCTIONS

3.1

GENERAL

TWN4 MultiTech Nano M may be installed in any host devices, as long as it is operated under the operational conditions stated in the
user manual and other technical documents (e.g. data sheet).
3.2

LIST OF APPLICABLE RULES

Refer to the approval certificates, grants and declarations of conformity issued for TWN4 MultiTech Nano M, and to the following rules
applicable to TWN4 MultiTech Nano M:
•
47 CFR 15.207
•
47 CFR 15.209
•
47 CFR 15.225
3.3

SPECIFIC OPERATIONAL USE CONDITIONS

TWN4 MultiTech Nano M is an RFID reader module without antenna that can be connected to an external antenna through a printed
circuit board (125 kHz, 13.56 MHz or both). TWN4 MultiTech Nano M has been tested with a printed circuit board equipped with
specific antennas (refer to Chapter "Antennas" for detailed information). The use of TWN4 MultiTech Nano M with other antennas is
technically possible. However, such use conditions require additional testing and/or approval.
If TWN4 MultiTech Nano M is used with antennas as described under Chapter "Antennas", there are no specific operational use
conditions other than the conditions mentioned in the user manual and data sheet of TWN4 MultiTech Nano M. The host manufacturer
or integrator must ensure that these use conditions comply with the use conditions of the host device. In addition, these use conditions
must be stated in the user manual of the host device.
3.4

LIMITED MODULE PROCEDURES

The integrator must perform tests to ensure that all applicable rule parts are kept in combination with the end device (refer to Chapter
"List of applicable rules").
3.5

TRACE ANTENNA DESIGN

For antenna information, refer to Chapter "Antennas".
© 2022 ELATEC GmbH – TWN4 MultiTech Nano M integration manual DocRev4 – 04/2022
•
RSS-Gen
•
RSS-102
•
RSS-210
Tolerances
Capacitors: 1%
Resistors: 2%
Page 5 of 11