Cuckoo CR-063F Series User Manual page 29

how to Adjust the Warm temperature
▶ Odor may develop from water drops or discolored rice from frequent use.
The warm temperature may be incorrect. Adjust the temperature.
❶ Press the "Keep Warm" button in
Keep Warm or Standby mode at
length over 5 sec. The display will
change and a buzzer will sound as
shown in the above figure. In the
figure, means the current
warm temperature.
※
The factory setting temperature may be different from the manual.
To adjust the warm temperature while keeping rice warm, press the "Keep Warm" button for over 5 seconds and adjust the warm
temperature.
1. A stale smell develops and water drops are formed: The warm temperature is low. Raise the temperature by 1 ~ 2℃.
2. The cooked rice turns yellow, the rice gets dry and an odor develops: The warm temperature is too high.
Lower the temperature by 1 ~ 2℃.
how to adjust the Customized Warm function
This function is used in case the water runs when you open the inner lid while keeping warm or the cooked rice is
swelled.
❶ Press the "Keep Warm/Reheat"
button in My mode.
The display part is changed and a
buzzer sounds as shown in the
above figure. In the figure, '
means default value.
1. If water runs out when you open the lid:
2. If the cooked rice is swollen around the edge of the rice:
TO kEEP RICE WARM AND TASTY
'
Press the "Hrs" button to raise the setting mode by 1 or 2 stages.
Press the "Min/My mode" button to lower the setting mode by 1 or 2 stages.
❷-❶ Press the "Hrs" button to change
the display part in turn of
❸ After setting the desired temperature,
press the "Cook, Keep Warm" and
"Timer" buttons to automatically enter
the value. At this time a buzzer sounds.
If you press the Cancel button or
7 seconds flow with no input, the
function is cancelled and the mode
returns to Standby mode.
❷-❷
Press the "Min" button to
change the display in turn of
❷-❶ Press the "Hrs" button to change
the display part in turn of
❸ After setting the desired value,
press the "Cook/Quick" button to
automatically enter the value. At
this time a buzzer will sound.
If you press the "Cancel" button or
7 seconds pass with no input, the
function is cancelled and the
mode returns to Standby.
❷-❷ Press the "Min/My mode" button to
change the display part in turn of
29