Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Focusrite vocaster hub
Summary of Contents for Focusrite vocaster hub
- Page 1 User Guide Version 1 Tell your stories Focusrite.com...
-
Page 2: Table Of Contents
Updating the Vocaster Hub Software........ -
Page 3: Introduction
INTRODUCTION Introduction Installing Vocaster Hub This is the User Guide for Vocaster Hub, the I can’t see my Vocaster in the software? software application you use to control your You can install Vocaster Hub on Windows and If your Vocaster is not recognised in Vocaster Vocaster interface. -
Page 4: Vocaster Hub Layout
Two connected and tell you when the features are Vocaster Two only. While the layout is different, how each section of Vocaster Hub works is the same. The following diagrams show the layouts for Vocaster One and Vocaster Two. -
Page 5: Key Features
VOCASTER HUB LAYOUT Key Features See “Speaker Mute” on page 8. Slider, Meter and Clip Indicator. See “Settings Page” on page 10 See ”Microphone Input Controls” on page 6 Guest Input Host Input See Mute, Enhance and Auto Gain “Mute” on page 7... -
Page 6: Microphone Input Controls
Mic Level Slider and Meter Meter Clip Indicator The Mic Level section of Vocaster Hub mirrors The meter is the section of the Mic Level The Clip Indicator is the red part at the far the preamp controls you have on the front of... -
Page 7: Mute
Enhance Presets Mute Enhance Enhance has presets that apply different The Mute button in Vocaster Hub does the The Enhance button applies three effects to parameters to your voice depending on how same job as the Mute button on the Vocaster: optimise your signal for voice recording. -
Page 8: Auto Gain
Most podcasting microphones don’t need this but if your microphone does, you can turn on Speak normally for ten seconds while the 48V using the button in Vocaster Hub. timer counts down. This is the same as pressing the 48V button on the Vocaster’s rear panel. -
Page 9: The Mix Section
Adjusts the level sent from a Bluetooth This is the main mix of all the Vocaster’s Device connected to your Vocaster Two to inputs. You can record the Vocaster Hub the Show Mix. Your Blutooth device’s volume mix by selecting the ‘Show Mix’ inputs your buttons will also control the Slider’s level. -
Page 10: Settings Page
After the update Vocaster Hub returns to the see our Privacy Policy for more information. main Vocaster window and you can continue to use your Vocaster. Update message: Your Vocaster will need to update before you can use it with Vocaster hub. focusrite.com Tell the world... -
Page 11: Enhance Presets' Parameters
+2dB 7000Hz +2dB -22dB +5dB Warm 80Hz 135Hz -1dB 450Hz +2.5dB 2500Hz -1dB -22dB +5dB Bright 80Hz 500Hz -2dB 2000Hz +3dB 11000Hz +3dB -22dB +5dB Radio 80Hz 100Hz +2.5dB 1000Hz -1.5dB 6000Hz 1.15 +1.5dB -22dB +5dB focusrite.com Tell the world... - Page 12 Focusrite Help Centre at support.focusrite.com Copyright & Legal Notices Focusrite is a registered trademark and Vocaster is a trademark of Focusrite Audio Engineering Limited. All other trademarks and trade names are the property of their respective owners. 2022 © Focusrite Audio Engineering Limited.
Need help?
Do you have a question about the vocaster hub and is the answer not in the manual?
Questions and answers