Download Print this page
Pondmaster CLEARGUARD 2700 Care And Operating Instructions
Hide thumbs Also See for CLEARGUARD 2700:

Advertisement

Quick Links

CARE AND OPERATING INSTRUCTIONS
MODELS
ITEM #
No UV
2700
05610
5500
05620
8000
05630
16000
05640
With UV
120V
230V
05615
05617
05625
05627
05635
05637
05645

Advertisement

loading
Need help?

Need help?

Do you have a question about the CLEARGUARD 2700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pondmaster CLEARGUARD 2700

  • Page 1 CARE AND OPERATING INSTRUCTIONS MODELS ITEM # No UV With UV 120V 230V 2700 05610 05615 05617 5500 05620 05625 05627 8000 05630 05635 05637 16000 05640 05645...
  • Page 2 Both biological and mechanical ltrations are essential for every pond; without them, your sh would be harmed by ammonia generated by the accumulated sh waste. The bene cial bacteria bed that builds on the lter media nitri es any ammonia in the pond making it a healthier environment for aquatic life.
  • Page 3: Important Safety Instructions

    ELECTRICAL PRECAUTIONS WARNING: FOR YOUR PROTECTION, ALWAYS UNPLUG THE UNIT FROM ITS POWER SOURCE BEFORE INSTALLING OR SERVICING. DO NOT REACH, REMOVE OR DISASSEMBLE BEFORE YOU DISCONNECT POWER. IMPORTANT SAFETY INSTRUCTIONS Use only three-wire outdoor extension cords that have three-prong grounding plugs and grounding recepta- cles-that accept the appliance’s plug.
  • Page 4 Filter Pumps Maximum Model up to: Pressure Your Pressurized Filter System works best within a certain range of ow and pressure. See table. Exceeding these values will cause leakage 2700 3000 GPH/11350 LPH 15 PSI/1 BAR/103kPa or breakage of the lter or its components and void the warranty. 5500 6000 GPH/22700 LPH 15 PSI/1 BAR/103kPa 8000...
  • Page 5 Once cover is pressed down evenly, place the clamp around the drum and cover anges and pull the open end closed. Note that it is best to position the open end of the clamp away from hose connections for easy access to the tightening knob once hoses are attached.
  • Page 6 Biomatrix media before backwashing. Note that for a more substan- tial power backwash, the Pondmaster Backwash Air kit can be attached to the drain valve to force air through the media releasing the excess waste. See Accessories section.
  • Page 7 To run a backwash cycle: 1) • Turn o pump & UV • Open lter • Remove lter pad. • Replace cover. 2) Check that waste hose is properly directing waste water to dry well or garden area. 3) Set valve to #4 BACKWASH and run the pump for a few minutes * 5) Set valve to position 2 “RINSE”.
  • Page 8 UV CLARIFIER INSTALLATION AND FIGURE 1 NOTE POSITION OF FLAT OPERATING INSTRUCTIONS: GASKET AND O-RING. FLAT GASKET If your pressure lter was supplied with a UV clari er, the lamp UV FIXTURE SEATS ON TOP WITH BALLAST OF QUARTZ must be installed. SLEEVE 1) Unscrew the threaded ring and remove the UV clari er / ballast assembly that is pre-installed into the cover of the lter.
  • Page 9 CAUTION: During harsh winters, water left in the drum may freeze, expand and crack the drum. If necessary, the lter can be drained and winterized at the end of the season. If you live in an area that doesn't experience freezing temperatures, you may never need to do this. To empty the water from the lter drum, follow the instructions below: 1) Turn o the pump and disconnect the power source to the UV.
  • Page 10 SYMPTOM POSSIBLE CAUSE SOLUTION Filter output is Remove rinse and replace lter pad. Filter Pad is clogged. Media needs cleaning. Backwash lter. See BACKWASH CYCLE. sluggish. Pump intake is clogged, Check pump and clear debris. Use a Pump Bag around Pump is undersized or pump to prevent future clogging.
  • Page 11 For reference only, all parts are not available individually. INCLUDED WITH ” INLET FITTINGS MODELS Includes parts: 1, 2, 3, 4 & O-rings ” WASTE / OUTLET FITTINGS 1 1/2” FITTINGS 2” FITTINGS Includes parts: 1.5” Outlets Collar     2”...
  • Page 12: Warranty

    To validate this warranty, keep your proof of purchase (copy of sales receipt from a certi ed Pondmaster dealer). Warranty covers the repair or prorated replacement of the Danner Mfg. products. Danner Mfg. denies all liability for any other loss including but not limited to loss of equipment, income, livestock, or personal injury.

This manual is also suitable for:

Clearguard 5500Clearguard 8000Clearguard 16000