Advertisement
5. ADJUSTMENT
5.1.
ADJUSTING THE HEADBAND CIRCUMFERENCE
5.1.1.
Adjust the headband circumference with the thumb wheel (fi g 5) located at the rear of the headband.
5.1.2.
Turn clockwise to tighten and counterclockwise to loosen.
5.2.
ADJUSTING THE HEADBAND HEIGHT
5.2.1.
Adjust the height by snapping the pins on the top band (fi g 6) of the headband into the desired position.
5.3.
ADJUSTING THE HEADBAND TILT ANGLE
5.3.1.
Adjust the tilt angle by loosening the thumbscrews (fi g 2) on both sides of the head shield and change the tilt tab to the desired
angle (fi g 3). There are four pre-set positions to select.
5.3.2.
Re-tighten the thumbscrews.
6. MAINTENANCE
6.1.
REPLACING THE SHADE LENS
6.1.1.
Flip up the front shade lens holder (fi g 7).
6.1.2.
Locate thumb or forefi nger under the lens retainer clip (fi g 8) and gently pull inwards and outwards and remove the lens retainer
and place in a secure position.
6.1.3.
Remove the shade lens and replace with a new one.
6.1.4.
Replace the lens retainer by clicking back into place.
6.1.5.
REPLACING THE CLEAR LENS
6.1.6.
Locate thumb or forefi nger under the lens retainer clip (fi g 8) and gently pull inwards and outwards and remove the lens retainer
and place in a secure position.
6.1.7.
Remove the clear lens and replace with new one.
6.1.8.
Replace the lens retainer by clicking back into place.
6.2.
CLEANING
6.2.1.
Clean with a soft cloth.
DO NOT use solvents.
© Jack Sealey Limited
fi g.1
fi g.3
fi g.5
fi g.7
Original Language Version
fi g.8
fi g.2
fi g.4
fi g.6
SSP101.V2 Issue 1 30/11/21
Advertisement
