Section 6: In-Vehicle Connections And Radio Unit Installation - PAC SR-TUN14H Manual

SR-TUN14H
Stinger HEIGH10 Radio Replacement Kit
®
for 2014-2021 Toyota Tundra

Section 6: In-Vehicle Connections and Radio Unit Installation

1
3 4
2
X
Step 3
Step 1 Step 2
Connect the BAA44 antennna
Plug in the GPS (3) and USB (4)
Connect the three (or four)
adapter to the HEIGH10 AM/FM
adapters. Note: The USB cable
vehicle side connectors on the
antenna input (1). Connect the
must be plugged into the USB port
SR-TUN14H main harness to the
other end to the vehicle's AM/FM
closest to edge of the radio chassis
matching vehicle radio plugs.
antenna (2).
for Apple CarPlay and Android Auto.
These are the connections for the basic installation. If adding additional components
such as a second USB, SXM tuner or additional cameras, those connections should be
made at this point, before mounting the radio module.
NOTE: If the External Microphone is not installed, the setting must be changed from
External (Default) to Internal in the Phone Settings:
Main Menu > Phone > Settings
Step 4 Step 5
Step 6
Push to seat the retaining clips.
Slide the radio assembly into Before reassembling the vehicle, it is
Install one of the 10mm bolts below
position and align the top recommended to proceed to Testing
the radio to temporarily hold it in
retaining clips to the sub-dash. and Verification on the next page.
place.
Rev: V2
®
Page 8
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Date:032222
Pacific Accessory Corporation