Table of Contents
Advertisement
SR-TUN14H
Stinger HEIGH10 Radio Replacement Kit
®
for 2014-2021 Toyota Tundra
Section 5: Main Frame Assembly
Step 3
Step 1
Step 2
Route the LVDS (USB) and 8-pin
With the display face down on a
Place the HEIGH10 display into
display cables to the front of the
soft surface, attach the display
the main frame panel. Carefully
to the panel using four M4 x
assembly, passing between the
turn the panel over while holding
radio module and the interface
12 screws from the HEIGH10
the display in place.
hardware pack.
bracket.
Step 4
Step 5
Step 6
Plug the display cables into the back
Align the right side bracket holes to
Align the left side bracket holes to
of the HEIGH10 display.
the main frame mounting holes and
the main frame mounting holes and
Place the complete radio and side
secure using two #10x3/8" screws
secure using two #10x3/8" screws
bracket assembly face down on the
from the SR-TUN14H hardware.
from the SR-TUN14H hardware.
main frame.
Step 7
Remove the two retaining clips from
the factory radio and install them
in the same location on the
SR-TUH14H main frame.
Rev: V2
®
Page 7
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Date:032222
Pacific Accessory Corporation
Advertisement
Table of Contents
