Table of Contents
Advertisement
3.2
Connecting to PC/Force Recovery Mode
On Host Computer, open Linux terminal and enter the following command to extract
compressed OS image files (file name may vary):
$ tar -zxvf ACLinux_4.9_NJ451X.NV05.BOXER-8254AI.2.tar.gz
Next, perform the following steps to force the system to start in USB Recovery Mode:
1.
Connect the Micro-USB plug on the USB cable to the Recovery Port on the
BOXER-8254AI and the other end to an available USB port on the host PC.
2.
Connect the BOXER-8254AI power supply.
3.
Press and hold the recovery key button. While holding the recovery key button,
power on the system, and continue to hold the recovery key button for two
seconds, then release. The BOXER-8254AI should enter recovery mode.
4.
To check if device is in recovery mode, enter lsusb command in terminal on
host.
$ lsusb | grep 0955:7e19
If successful, the command will return "0955:7e19 Nvidia Corp"
Recovery mode can be initiated with the system disassembled. Ensure the NVIDIA
Jetson Xavier NX module is installed and refer to the image below to perform the steps:
Micro-USB
Chapter 3 – OS Flash guide
Power
Power
Supply
Key
Recovery
Key
29
Advertisement
Table of Contents
