Stopping and parking
Close the throttle completely and apply the brake.
●
As the vehicle speed reduces depress the clutch lever
●
and down shift the gears.
Bring the transmission to neutral position just before
●
vehicle stops.
Press the Self Starter switch continuously for 2 sec
●
when the vehicle is in idling RPM (<1500 RPM) &
Neutral condition to stop the engine, then turn
ignition switch to OFF position and take out the key.
Apply parking brake. Lock the steering by turning the
●
handle bar to the right.(Refer page no.21.)
WARNING
Do not press the clutch while braking at high speeds.
Always apply the parking brake while parking on
gradient.
Reverse gear operation
●
Bring the vehicle in neutral position
●
Allow the vehicle to stop completely
●
Press the clutch lever.
●
Turn the gear change twist grip upwards to move to
alert 'A' position, beeper sound can be hear.
●
Turn the gear change twist grip upwards to reverse 'R'
position to engage the reverse gear. (Refer fig.)
●
Engage the clutch gradually to move the vehicle.
Operating your vehicle
Reverse gear operation
Fuel saving tips
● Carry out the periodic maintenance services regularly at
TVS authorised distributor or dealers / authorized service
center.
● Perform daily checks as specified in page no 32.
● Avoid sudden and frequent braking.
● Use Start Stop function to switch OFF the engine if you
have to idle the vehicle for more than 1 minutes.
● Clean, check and adjust the sparkplug gap periodically.
(Refer fig.)
For service procedure (See page no. 44)
● Clean air filter element as per schedule (See page53)
● Lubricate propeller shaft, slider block, pin and flange as
per lubrication schedule.(Page no.47)
036
A