Table of Contents
Advertisement
Reversed Supplies Installation
For reversed supplies installation the
cartridge must be rotated 180° to ensure
proper valve operation.
1.Shut off hot and cold water supply!
2.Remove the connection nipple (K), see
Fig. [12].
12
K
3.Pull off cap (P), loosen centre screw (O1)
and pull off handle (O).
4.Detach hot water limit stop (N) and note
position.
5.Remove screws (M1), washers (M) and
scale ring (L).
6.Remove screws (G1) and chassis (G),
see Fig. [13].
13
S
S1
R
J
J1
Installation
L
M
N
M1
O
O1
P
G
G1
10
7.Loosen screw (J1) and pull off driver (J).
8.Detach stop ring (R) and note position.
9.Remove the four corner screws (S1) and
valve cover (S).
10. Pull the pressure balancing cartridge (T)
out of the valve body. Do not damage
the O-ring seals, see Fig. [14].
14
Z
Reverse the pressure balancing cartridge
180° by turning it upside down. Place it
into the valve body. Ensure the two
alignment pins (T1) on the rear of the
pressure balancing cartridge are properly
seated in the holes (Z) of the valve body.
Notice the position of hot "H" and cold "C"
markings on the cartridge to assure the
correct position in relation to reversed or
back to back installation.
Reassemble in reverse order. Be sure that
the stop ring (R) and the hot water limit
stop (N) are in the previously noted position.
T1
T
Advertisement
Table of Contents
