Operation • Setting Key - TAJIMA TCMX 601 User Manual

3-2
Operation panel
1.
Operation • setting key
1.
Sleep mode (power save mode) key (p.6-7)
Setting condition of automatic/manual start
Lit: automatic Unlit: manual
2.
Setting condition of automatic/manual start (p.4-8)
Lit: automatic
Unlit: manual
3.
Frame back/forward setting indicator lamp (p.5-15)
Lit: frame back
Unlit: frame forward
4.
Display of the fixed position
Lit: The main shaft is stopped at the fixed position.
Blinking: The main shaft stops at the lower dead point.
5.
Floppy disk drive operation indicator lamp
Lit: working
6.
Memory card operation indicator lamp
Lit: working
7.
Confirmation mode key (p.6-2)
A key for confirming setting contents
8.
Function call key
Key that calls each function
It is also possible to move the cursor to the lower row in the list
screen (p.3-4).
9.
Jog dial/jog shuttle
There are following three functions.
Traveling of frame (p.3-5)
Selection of input value
Change of max revolution (during operation) (p.3-6)
10.
Reset key (E key)
When a code number is displayed, it is used as reset key. Pressing
this key will make travel of the embroidery frame possible by the
jog dial/jog shuttle (manual frame travel mode). To cancel "manual
frame travel mode", press other operation key.
11.
Set key
Use it when deciding the input value or the selected item, and
executing the contents of manual operation.
12.
Manual frame travel key
Use this when moving the embroidery frame manually (p.3-5). In
the list screen, it is also possible to move the cursor up and down
(p.3-4).
13.
Frame travel speed switching key (p.3-5)
Key to switch frame travel speed to high speed/low speed at manual
frame travel
Main screen (p.3-3)
7
1 2 3 4 5 6
8
Jog dial/jog shuttle
Jog shuttle
Fast feed of an input value
Jog dial
Increase or decrease input value in increments of "1" at the
digit of setting unit.
In operating instructions in this manual (p.4-2 and
after), the jog dial/jog shuttle is displayed as shown
below.
Jog shuttle
Jog dial
10
9
11
12 12
13
JZ07