LGB K.sa.St.E. Dampflok I M Manual page 11

Register Assignment
1 Address
2 Minimum speed
3 Acceleration delay
4 Braking delay
5 Maximum speed
8 Reset
13 Function F1 – F8 with alternative track signal
14 Function FL, F9 – F15 with alternative track signal
17 Expanded address, higher value byte
18 Expanded address, lower value byte
19 Multiple unit operation address
21 Functions F1 – F8 with multiple unit operation
22 Function FL, F9 – F15 with multiple unit operation
Bit 4: Braking mode voltage against the direction of travel
27
Bit 5: Braking mode voltage with the direction of travel
Bit 0: Direction normal/inverted
Bit 1: Number of speed levels 14/28(128)
29
Bit 2: Analog operation off/on
Bit 5: short / long address active
Alternative Formats'
Bit 1: Analog DC
50
Bit 2: MM
Bit 3: mfx off/on
Multi-station announcement
Bit 0 – 3: Number of stations
60 Bit 4: Last announcement changes the sequence
Bit 5: Locomotive direction changes the sequence
Bit 6: Start for the sequence
63 Total volume
64 Threshhold for squealing brakes
Range Default Register Assignment
1 – 127 3 67 – 94 Speed table for speed levels 1 – 28
0 – 255 7 112
0 – 71 8 113
0 – 71 8 114
0 – 255 190 176
8 159 177
0 – 255 36
Note:
0 – 255 1
At www.LGB.de you will find a tool you can use to calculate different decoder set-
tings as well an extensive description of the decoder and the settings. Programming
192 – 231 192
the decoder settings with the 55015 Universal Hand Controller is also explained in
0 – 255 128
these instructions.
0 – 255 0
0 – 255 0
0 – 255 0
0/16
16
0/32
0/1
0/2
6
0/4
0/32
0/2
14
0/4
0/8
0 – 15
0/16 40
0/32
0/64
0 – 255 255
0 – 255 10
11
Mapping lights in the front, mode
Mapping lights in the front, dimmer
Mapping lights in the front, cycle
Minimum speed in analog DC
Maximum speed in analog DC
Range Default
0 – 255
0 – 21 1
0 – 255 255
0 – 255 20
1 – 255 50
1 – 255 130