Application Advice - Skil 8200 Original Instructions Manual

Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
users.
Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc., in
accordance with these instructions, taking into
account the working conditions and the work to be
performed.
5) SERVICE
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
SAFETY INSTRUCTIONS FOR TACKERS
Always assume that the tool contains fasteners
Do not point the tool towards yourself or anyone
nearby
Do not actuate the tool unless the tool is placed
firmly against the workpiece
Disconnect the tool from the power source when the
fastener jams in the tool
Use caution while removing a jammed fastener (the
Do not use this tacker for fastening electrical cables
Secure the workpiece (a workpiece clamped with
when original accessories are used
you start working
EXPLANATION OF SYMBOLS ON TOOL
3 Read the instruction manual before use
4 Double insulation (no earth wire required)
5 Do not dispose of the tool together with household
waste material
USE
! disconnect the plug
- turn tool upside down
- push slider B against tacker head D until it snap-locks
nail symbol on tacker head D 7
shows in opening H 2
8
- switch on the tool by pushing switch E in "I" position
it is pushed in completely
! while working, always hold the tool at the
grey-coloured grip area(s)
9
and walls
testing out on spare material

APPLICATION ADVICE

0
!
supplied with the tool
impact strike
7
6