Table of Contents
Advertisement
Four-Point Probe System
7.
System Components
The Four-Point Probe System is comprised of: the Ossila Four-Point Probe System (Figure 7.1) and
the Ossila Sheet Resistance Software (Figure 7.2).
8.
Installation
1. Install the Ossila Sheet Resistance Lite software on your PC.
I.
Run the file 'Ossila-Sheet-Resistance-Lite-Installer-vX-X-X-X.exe' on the USB
memory stick provided.
II. Follow the on-screen instructions to install the software.
2. Connect the 24 VDC power adaptor to the power socket on the rear of the unit.
3. Connect the unit to your PC using the provided USB-B cable, or an Ethernet cable if
preferred.
I.
If you are using a USB connection and the unit is not detected, please refer to the
SMU USB Driver Installation Guide found on the USB memory stick.
Note: The Ossila Sheet Resistance Lite software and Source Measure Unit USB drivers can
also be downloaded from
Ossila.com
Figure 7.1. The Ossila Four-Point Probe.
Figure 7.2. The Ossila Sheet Resistance Lite software.
ossila.com/pages/software-drivers
11
User Manual
Ossila Limited © 2022
Advertisement
Table of Contents
