JVC TK-C215VP4 Installation Precautions page 2

Safety Precautions
Precautions regarding fall prevention
warning
Mounting to a firm place.
When mounting this unit to the ceiling or wall,
mount it to a secure location where it can
support the mass of this unit. When mounting
to an insecure location, make sure to carry out
reinforcement of the ceiling or wall before
installation.
The camera unit may fall if the mounting screw
or piping is not properly tightened. Ensure that
the screws and nuts are properly tightened.
Mounting the fall prevention wire
Connect the fall prevention wire to prevent this
unit from falling accidentally. The camera unit
may fall if this wire is not connected.
All manuals and user guides at all-guides.com
Be sure to use M4 screw.
Note:
● Pay attention to the length, strength, routing
● The internal diameter of the rounded portion
● When mounting the fall prevention wire to the
Note:
● When mounting the base to the ceiling, or
Mounting screws for the base
Mounting the fall prevention wire
and material (insulation properties) of the fall
prevention wire used.
on the camera unit to which the fall
prevention wire is to be mounted shall be at
least R 4.1 mm and not larger than R 6.5 mm,
and its external diameter shall not be larger
than R12 mm.
base, be sure to use the M4 screws mounted
on the base.
Base
R4 mm screw
Handling camera
when connecting the cable of the camera
unit, pay enough attention to the fall of each
part.
Fall Prevention
Wire
8 mm
2 mm
M4 screw
(Attached to the base)