ABB ACH550 Quick Start Manual page 2

Hide thumbs Also See for ACH550:

ACH550 Control Panel (ACH-CP-B) & Ethernet Cable – For Control Panel (ACH-CP-B) Interface to control board

(SMIO-01).

OPCA-01 (DB9 to RJ45 Connector), USB to 232 Connector, & Computer with Drive Windows Light – For Drive

Windows Light interface to control board (SMIO-01). Note that this hardware is only required if using Drive

Windows Light in place of the control panel.

Existing installation board recovery & interface board installation instructions

*Before you begin, ensure that the lock out tag out procedures have been completed and that there is no power to the

work area or drive. Later follow proper ESD (electrostatic discharge) guidelines when working with the bare circuit

boards.

Step 1: Remove existing panel if installed.

Step 2: Remove existing mounting screw and remove cover by pushing tabs at the side of the cover and lifting and

pulling forward.

LVD-EOTKN094U-EN REV A

Effective: 2022-06-30