Initialisation; Troubleshooting - Samsung HW-S60T Full Manual

Soundbar by connecting the USB drive that
contains the update firmware to the SERVICE port
of the Soundbar.
1. Go to the Samsung website
(www.samsung.com) → search for the model
name from the customer support menu option.
• For more information about update, refer
to Upgrade Guide.
2. Download the upgrade file (USB type).
3. Unzip the file to create a folder with the file
name.
4. Store the created folder in a USB and then
connect it to the Soundbar.
5. Turn on the Soundbar. Then the product is
updated within 3 minutes.
LED
Indicator
Software update start : "Start
the software update."
Software update end : "The
software update is complete."
• During update, do not turn it off or remove
the USB.
• If the yellow LED is on after the software
update is completed, this means that an
additional update is in progress. When this
happens, don't turn off the power or
remove the USB.
• If update does not proceed, reconnect the
Soundbar power cord.

12 TROUBLESHOOTING

Refer to the instructions below if this product does not function properly.
In case the power is not turned on
• When the latest version is installed, no
update is performed.
• Depending on the USB type, update may
not be supported.

Initialisation

buttons on the body at the same time for at least
5 seconds. The LED display changes as shown
below and then the Soundbar is initialised.
LED
Indicator
CAUTION
• All the settings of the Soundbar are initialised.
Be sure to perform this only when
initialisation is required.
ENG - 35