Sony SRP-X351P Operating Instructions Manual page 5

!£ MIC 1/MIC 2 fader knobs
Use to adjust the mixing level of MIC 1/MIC 2.
Either the wireless microphone or the wired micro-
phone can be used in MIC 1/MIC 2.
(Refer to page 6 and page 9.)
When the WRU-801A or WRU-806A (optional) is
put in to the tuner unit compartment at the rear panel,
the wireless microphone is given priority while it is
on.
!¢ MIC 3 fader knob
Use to adjust the mixing level of MIC 3.
Only the wired microphone can be used in MIC 3.
!∞ MIC 4 fader knob
Use to adjust the mixing level of MIC 4.
!§ ST1 fader knob
Use to adjust the mixing level of ST1.
A playback unit will be connected to it mainly.
!¶ ST2 fader knob
Use to adjust the mixing level of ST2.
The sound signal of this channel is not output to the
REC OUTPUT terminal; you can use without being
bothered about oscillation from signal loop.
SRP-X351P
INPUT
ST2
×REC
Sound signal of
OUTPUT
except ST2
MASTER
!• ST3 Fader knob
Use to adjust the level of the signal from AV equip-
ment selected by the SELECT button stated in !ª.
!ª SELECT buttons
@º MIC GROUP knob
@¡ Bass control knob
@™ TREBLE control knob
@£ BALANCE adjustment knob
Recorder/Player
OUTPUT
When
recording
INPUT
Use to select one of the unit connected to ST3 A to D
input.
S VIDEO and VIDEO signal from the selected input
is directly output to the MASTER OUTPUT and the
REC OUTPUT.
The mixing level of the sound signal can be adjusted
by ST3 fader knob.
Use to adjust the level of the signal after mixing in
MIC 1 to 4 in a lump.
The signal will be output from the MIC GROUP OUT
terminal.
Use to adjust low frequency among the sound from
the MASTER OUTPUT or SPEAKER terminal.
Use to adjust high frequency among the sound from
the MASTER OUTPUT or SPEAKER terminal.
Use to adjust the balance of left and right of the sound
from the MASTER OUTPUT or SPEAKER terminal.
Note
When the PROTECTION indicator lights up
The protection circuit triggers and the PROTECTION indicator
lights up in following conditions. In this case, the speaker and
amplifier are protected by cutting output.
• When direct-current voltage appears in the SPEAKER
terminal from a malfunction.
• When rated temperature of amplifier internal heat sink is
exceeded.
• When impedance of the connected speaker is too low, or
when speaker outputs are shorted.
When the above happens, turn off the POWER switch, find
and fix the cause of the problem, and restart.
5