Cleaning Carpets - Bissell POWERSTEAMER PROHEAT PLUS 16981 Series User Manual

The Flow Indic ator
This is located on the m achine base. It spins when
the trigger is pressed to indicate that the m achine
is applying cleaning solution to the floor. It will
stop spinning to indicate that the Sm artMix
Bottle or bladder needs to be refilled, or when
the trigger is released.
™
ReadyTools Switc h
This provides above floor cleaning with the
flip of a switch. Just choose the cleaning
tool, attach to the flex hose and
®
POWERSTEAMER PROHEA T
PLUS is ready to clean
upholstery and m ore.*
Floor
* Set the switch to
Clean in g
when
clea n in g ca rpets or
b a re floors or set it
Tools/PreTreat
to
when u sin g the flex hose
a tta chm en ts or for pre-trea tin g floors.
™
* Sm a rtTem p hea ts the clea n in g solu tion for
ca rpet a n d b a re floor a pplica tion on ly. It d oes n ot
hea t solu tion spra yed throu gh the a ccessory tools.
How to use Tur boBr ush
Assembly
Unplug before attaching the TurboBrush.
™
TurboBrush to the flex hose by pressing tool onto the
grip/trigger until button snaps into hole.
Make certain tool is securely in place.
Use
™
1. Move the TurboBrush
This activates the brush.
2. Place the tool directly on the soiled surface.
Apply downward pressure on the tool and
pull towards you while pulling trigger to
spray cleaning solution.
3. Release the spray trigger and m ove the
switch to the "SUCTION" position.
Vacuum the area until no m ore cleaning
solution can be rem oved.
4. Repeat steps 1-3 until no m ore dirt can be rem oved.
Cau tion : Do n ot overwet.
®
™
™
attachment
™
Attach
switch to the "BRUSH" position.
Tip:
Flow Indic ator
A spec ial red
float devic e in
the tank will
c ause the
c leaner to
stop removing
solution from
the c arpet and
the motor sound
will rise in pitc h
to let you know
the dirty water
tank is full.
™
ReadyTools Switc h
When You're Done
1. Disconnect the TurboBrush
the vacuum flex hose by pushing
down on the button lock and
pulling straight off.
2. Once rem oved from the flex hose, the
™
TurboBrush can be cleaned:
1. Move the switch to the
"SUCTION" position.
2. Rinse under running water.
3. Check spray nozzle for dirt.
If necessary, clean with soft
bristle brush.
4. Replace TurboBrush
special storage location on the
handle front.
™
from
™
in its
9