Cleaning Your Floors - Bissell CROSSWAVE 1785A User Manual

Cleaning Your Floors

Visit support.BISSELL.com to watch additional how-to videos.
Hard Floor
Rug
1.
To turn the machine ON, press
the hard floor or rug button.
Hard Floor: Everyday messes
on sealed hard floors, like
tracked-in mud, spilled cereal
and milk, coffee, and more.
Rug: Refresh and clean dry
messes, like crumbs, dirt, hair,
and more.
4.
Hold the solution spray
trigger to apply solution on
forward and backward passes.
Cleaning with Hard Floor Sanitize Formula
Please read "DIRECTIONS FOR USE" on Hard Floor Sanitize formula label. Use on hard nonporous
floors only.
1.
Remove visible soil before
cleaning. Hold trigger down to
apply solution on to the floor.
ATTENTION
rugs. Stalling the brush may result in premature belt failure.
2.
Recline to start the brush
roll spinning. Brush roll will not
spin when machine is upright.
5.
Release the trigger and
make a backward pass without
dispensing solution. To dry
floors faster, make additional
dry passes.
2.
Allow formula to remain wet
on the floor for five minutes.
Additional wet passes may be
necessary.
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
3.
Before each use, hold the
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights will illuminate when
holding the solution spray
trigger. Bubbles will appear in
the brush roll window when the
solution is flowing.
Hard Floor
Rug
6.
Press the rug or hard floor
button to turn the machine OFF.
3.
With the trigger released,
make forward and backward
passes to extract solution.
BISSELL.com 5