Table of Contents
Advertisement
Available languages
Available languages
English
1. To attach the blower tube
up the peg
8
of the power head with the notch
blower tube opening as shown in Fig. B.
2. Push the blower tube onto the power head until the tube
locks
4
engage the blower tube and an audible click
is heard.
3. Pull on the tube to ensure it is securely in place.
4. To remove the blower tube, squeeze both tabs
side of the power head and pull the blower tube off.
Attaching an Extension Cord (Fig. C)
WARNING:
is not engaged to reduce the risk of starting the
appliance accidentally.
A cord retention hook 6 is incorporated into the rear of the
handle on the power head.
1. Near the end of the extension cord, fold the extension
cord to create a loop.
2. Feed the loop into the cord retainer housing 10 as
shown in Fig. C
3. Hook the loop onto the cord retention hook 6 so it rests
in the cord retainer.
4. Plug the extension cord into the unit.
OPERATION
WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Proper Hand Position (Fig. D)
WARNING:
personal injury, ALWAYS use proper hand position
as shown.
WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Proper hand position requires one hand on the main handle 2 .
WARNING:
without blow tube securely in place. Never reach down
into housing through tube hole.
WARNING:
glasses. Wear a filter mask if the operation is dusty.
Use of rubber gloves and substantial footwear is
recommended when working outdoors. Keep long hair
and loose clothing away from openings and moving
parts. For household use only.
6
3
to the power head
5
, line
9
4
on the
Ensure the ON/OFF switch
To reduce the risk of
To reduce the risk of serious
To reduce the risk of serious
Do not operate blower
Always wear safety
WARNING:
of the
the tool off, wait 10 seconds for the fan to stop rotating
before removing the blower tube.
•
Always ensure the blower is switched OFF and
disconnected from the power supply when:
-
You leave blower unattended.
-
Clearing a blockage.
-
Checking, adjusting, cleaning or working on blower.
•
Only use blower in daylight or good artificial light.
Switching ON/OFF (Fig. A, D)
WARNING:
product firmly when switching on.
CAUTION:
self or bystanders.
Your blower is fitted with a 2 speed ON/OFF switch located
on the top of the main handle
•
To switch the blower ON, slide the ON/OFF
forward to position 1.
•
To operate blower in high speed, slide the ON/OFF
switch forward to position 2.
•
To switch the blower off, slide the ON/OFF
switch back.
MAINTENANCE
WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Cleaning
WARNING:
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when
performing this procedure.
WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
Cut Hazard. When turning
Use both hands to grip the
Do not point unit discharge at
2
.
1
switch
1
To reduce the risk of
Blow dirt and dust out
Never use solvents or other
1
Advertisement
Table of Contents
