Installation
Table 2-3 Available IPMI Sensors (continued)
Sensor Name
Voltage +5V USB1
Voltage +5V USB2
Volt +5V KB PWR
ARTM FW Revision
ARTM-7221 MMC
BOOT FW Revision
The location of the temperature sensor ARTM7221 Temp. is shown in the following figure.
Figure 2-23 Location of IPMI Temperature Sensor
Location of IPMI sensor
ARTM-7221 Temp.
For further details about IPMI sensors as well as supported IPMI commands, refer to the
ACC/ARTM-7221/FC: Control via IPMI Programmer's Guide which can be downloaded from
the Emerson literature catalog.
50
Devices Connected to RTM's Mezzanine Management Controller
Type of
Measurement
What does it measure?
Voltage
+5V voltage level of USB interface
1
Voltage
+5V voltage level of USB interface
2
Voltage
+5V voltage level of
keyboard/mouse interface
Firmware revision
Application firmware revision
Reset type
Status and type of the last reset of
the IPMC
Firmware revision
Boot loader firmware revision
ACC/ARTM-7221/FC Installation Guide (6806800E98A)
Sensor
Sensor
Type
Availability
Analog
While Payload
powered ON
Analog
While Payload
powered ON
Analog
While Payload
powered ON
Discrete
Always
Discrete
Always
Discrete
Always