Table of Contents
Advertisement
1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
NOTE
After the set assembling, perform the following process so
that the wires don't touch to the heating parts.
1.
Bind the CD7304, CD504 and Fan motor cable at the
Fig. 1 position and fix them.
2.
Pass the Fan motor cable through before the CD502
like the Fig. 1.
3.
Pass the CD7304 through under the CD502 them plug
in the connector like the Fig. 2. (Because, this prevent
from the contact with the VCR Deck.)
CD7304
Fix
CD7304
Fix
DISASSEMBLY INSTRUCTIONS
CD504
Fan motor cable
Fig. 1
CD502
Fig. 2
1-1: TOP CABINET AND FRONT CABINET
(Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2.
Remove the Top Cabinet in the direction of arrow (A).
3.
Disconnect the following connectors: (CP654, CP681).
Unlock the 8 supports 2.
4.
5.
Remove the Front Cabinet in the direction of arrow (B).
Remove the 5 screws 3.
6.
7.
Remove the Operation 1/2 PCB in the direction of
arrow (C).
Operation 2 PCB
Front Cabinet
3
3
(C)
(B)
2
2
2
2
2
2
1-2: FLAP (Refer to Fig. 1-2)
1.
Open Flap to 90˚ and flex in direction of arrow (A), at
the same time slide in direction of arrow (B).
2.
Then lift in direction of arrow (C).
(C)
B1-1
1
Top Cabinet
1
(A)
3
3
3
(C)
2
Operation 1 PCB
2
(A)
(B)
Flap
1
1
1
Fig. 1-1
Fig. 1-2
Advertisement
Table of Contents
