Table of Contents
Advertisement
2
3. SET-UP & OPERATION
-i- BRUSH MOUNTING
*Refer to the Power Unit operator's manual for
instructions on assembly of the Power Unit.
1. Loosen the motor plate on the Power Unit (Refer to
Power Unit Manual for illustration)
2. Take the belt, slide over pulley on broom and the
upper pulley on the Interframe (Figure 3-1).
Figure 3- 1
3. Tighten the motor plate on the Power Unit
Engage both locking clips on the brush (one on
each side) as shown in Figure 3-2.
Pivot Stop Pin
Figure 3-2
5. Attach the winch cable to the last chain link to
prevent the brush from hitting the ATV when winch
is reeled in. Depending on winch location on the
ATV, a higher lift is required to use the second link,
but only if it cannot interfere with the ATV when
lifted.
Quad Power Brush
-ii- ANGLE ADJUSTMENT
Manual
Remove Pivot stop pin (shown in Fig 3-2) and manually
adjust angle by rotating brush to desired angle and
reinsert pin
Electrical Pivot (Option)
An electrical pivot option is available and is setup as
shown in the Figure 3-3
1. Bracket. 2. Actuator. 3. Washers. 4. Bracket. 5. Pin
Figure 3-3
Attach the supplied wiring harnesses to the ATV as
shown in Figure 3-4.
Locking Clip
Figure 3-4
Attach the switch to the front rack of the ATV with the
bracket.
Operators Manual – Version 06
NOTE: Identify with the
battery of the ATV to ensure
which are the Positive (+)
and the Negative (-) poles.
Advertisement
Table of Contents
