Table of Contents
Advertisement
Figure 3
1. Locknut (3/8 inch)
2. Clamp
4.
Install the latches to both sides of the back plate
using 4 phillips-head screws, 4 lock washers,
and 4 locknuts (#10);
Important:
Do not completely tighten the
nuts; the latches should be able to move up
and down.
Figure 4
1. Left latch
2. Phillips-head screw
3. Lock washer
g314783
3. Bolt (3/8 x 3/4 inch)
Figure
4.
g314784
4. Right latch
5. Locknut (#10)
3
Assembling the Bag and
Frame
Parts needed for this procedure:
1
Bag and pan
1
Catcher frame
2
Handle
4
Bolt (1/4 x 1 inch)
4
Locknut (1/4 inch)
4
Washer (1/4 inch)
Procedure
1.
Slide the upper curved portion of the bagger
frame into the bag and the long straight rod
down toward the pan.
2.
Snap the J-strips over the frame rods
1. Rod
3.
Arrange the bag around the frame.
4.
Place the handles over the slots on each side
of the frame.
5.
Push 2 bolts (1/4 x 1 inch) through each handle
and the fabric from the outside, and secure them
with 4 washers (1/4 inch), and locknuts (1/4
inch) as shown in
3
(Figure
Figure 5
2. J-strip
Figure
6.
5).
g002158
Advertisement
Table of Contents
