Eureka Forbes Aquaguard GLORY User Manual

WHY CHOOSE AQUAGUARD

Only Aquaguard
®
•
Has the trust of over 15 million mothers
•
Is owned by over 1.62 lakh doctors
•
Has service within 5 kms. range of wherever you are
•
Has over 21 different technologies to address 21 different water conditions
across the country
•
Is certified by over 130 leading national and international laboratories
•
Is sold in over 35 countries worldwide
INSTALLING YOUR AQUAGUARD
Make sure that your Aquaguard Glory is installed by a trained Eureka Forbes
®
Service Technician only.
1. Input water must be tested for Total Dissolved Solids (TDS) and Total Hardness.
2. Install your Aquaguard Glory in a dry ventilated place.
®
- Keep it away from direct sunlight, heating devices or areas below freezing
temperatures.
- You can keep it on the kitchen counter or wall-mount it.
- The purifier should be placed in an area which is free of ants, insects and
other pests.
3. Ensure that the input tap water temperature is in the range of 10º-40ºC.
- Avoid installation to a hot water tap as it can damage the filters.
4. Ensure that the input water pressure for Aquaguard
ALKALINE is between 0.3 kg/cm
2
more than specified, installation of a PRV (Pressure Reducing Valve)** is
mandatory. If the input water pressure is less than specified, installation of a
booster pump** is recommended.
5. Flush filter thoroughly and independently for 3-5 minutes to remove fine
particles present in the filter. This should be done before installation of the unit.
6. After installing, run the purifier for 5-10 minutes and drain this water.
** Available at extra cost
?
®
^
GLORY
®
Glory RO+UV+MTDS+
®
– 3.0 kg/cm . If the input water pressure is
2
GLORY
INSTALLING YOUR AQUAGUARD
Input Water Quality Usage Limitations:
1. If the input water iron content is more than 0.3 mg/litre, use of an iron
remover** is recommended as a pre-treatment.
2. If the input water turbidity is more than 5 NTU or comprises colloidal particles,
use of a special filter** is required as a pre-filter.
3. If the input water TDS is more than 1000 ppm (mg/L) or input water hardness
is more than 300 ppm (mg/L), use of a Membrane life enhancer** is
recommended.
4. Do not install the water purifier if the TDS is more than that prescribed in the
MTDS REGULATOR OPERATING PROCEDURE: (Only Applicable for
RO+UV+MTDS+ALKALINE Models)
TDS modulator is located inside the product. As per factory setting, it comes in
fully closed mode. TDS level of output water can be increased by slowly
loosening the spindle of the TDS modulator (anti-clockwise). Normally a slight
quarter turn is enough to increase the TDS of the output water. Rotating the
spindle in the clockwise direction closes the TDS modulator and reduces the level
of TDS blending.
Please note that the TDS blending, and its adjustment is dependent upon the
level of TDS of input water and on the TDS reduction capacity of the RO
membrane. TDS adjustment should be done by the authorised Eureka Forbes
** Available at extra cost
GLORY
GLORY
®