Advertisement
ASSEMBLING & INSTALLING THE DUPLICATOR ON A WOOD LATHE
TEMPLATE CLAMPING BRACKET ASSEMBLIES
A
1.
Assemble the clamping bracket components A as shown in B. and set them aside for now.
ASSEMBLING THE CLAMPING PLATE HARDWARE
1. Lay one clamping plate A on a flat surface with the flat
side down
.
2. Thread one 12 mm set screw B into the threaded hole
in the clamping plate until it is flush with the flat surface.
3. Thread a M12 nut C onto the set screw until it touches
the clamping plate.
4. Using the 6 mm allen wrench, hold the set screw while
tightening the nut with the supplied 19 mm wrench as
shown.
5. Do this for both of the clamping plates.
ASSEMBLING THE CLAMPING PLATES TO THE SUPPORT BEAMS
D
1. Fit the set screws on the clamping plates into the slot
D on the support beams and secure them to the
beams with a 12 x P26 washer E and M12 hex nut F,
leaving them loose for now G.
6
G
E
F
B
A
B
C
H
On lathes that have a swing of 14" or more:
H
Bolt
is used as an alignment stop to set the duplica-
tor parallel to the bed ways. It makes it much quicker
when re-mounting the duplicator by pre-setting the posi-
tion the duplicator was in before you removed it.
Note: If your wood lathe swing diameter is 12", then DO
NOT install the alignment bolt
2. For lathes with a swing of 14" or more, install a 12
mm x 65 mm long alignment bolt H and thread into
each support beam until it is flush with the other si-
de of the hole.
I
H
G
on the support beams.
Advertisement
