Advertisement
ADJUSTING SPRING TENSION
The follower arm and stylus are kept against the tem-
plate or sample turning by spring pressure. If the move-
ment is not smooth you can adjust it.
Turn the wing nut:
-
clockwise to increase spring tension.
-
counter-clockwise to decrease spring tension.
FOLLOWER ARM AND STYLUS
The stylus is mounted onto the follower arm off center
(eccentric) so that it can be fine tuned.
To micro adjust the stylus loosen the follower arm locking
bolt using the supplied 12 mm open end wrench and
rotate the follower arm left or right. Re-tighten the locking
bolt when set.
OPERATION
TURNING THE HANDWHEEL FOR DUPLICATING
TO AVOID HAND INJURY WHEN TURNING THE HANDWHEEL,
PROPER TECHNIQUE SHOULD BE USED. HOLD THE HANDLES
ON THE HANDWHEEL ONLY - DO NOT HOLD AND TURN THE
HANDWHEEL BY ITS RIM.
16
MICRO ADJUST DEPTH CONTROL KNOB
As a turning approaches it's finished size, a final light
pass of the cutting tool will give a smoother finish*. Turn
the micro adjust depth knob clockwise until final depth
is obtained.
* Note: Depending on the level of detail in your template
or original spindle, some manual shaping of fine details
and finish sanding will still be required.
CORRECT
INCORRECT
Advertisement
