P San; Boil - Ferroli CRONO REM User Manual

10.5 P saN

The P SAN submenu allows modification of the DHW circuit setpoint.
1. SANIt = DHW setpoint in the ON bands of programming
2. HW MX = maximum DHW set point, max. 65 °C (visible only in INSTALLATER menu)
3. HW MN = minimum DHW set point, min. 20 °C (visible only in INSTALLATER menu)
4. RIDOt = DHW set point in OFF bands of programming (for versions with storage tank)

10.6 BOIL

The BOIL submenu can only be accessed from the INsT level, after setting the correct password in PaRaM
→ PSW (PSW = 77).
Here it is possible to view and modify the TSP parameters that are communicated by the boiler card.
Within the BOIL submenu, press the buttons
is displayed steady. To modify it, press the button
and (or the buttons
To confirm the new value, press the button
The symbol "- -" will be displayed for a few seconds, the new value will be displayed only after the boiler card has
accepted it.
Note The displayed value depends on the response of the boiler card to the Remote Control.
Examples:
1. The sent value is within the allowed range for this parameter→ the displayed value corresponds to the sent value.
82
EN
and
: the value of the parameter will blink. Use the buttons
and ) to change the value.
: the new value is sent to the boiler card only after this action.
cod. 3542A970 - Rev 01 - 03/2022
to scroll the list of TsPs. The value of the parameter