SILENTRON PhotoPir 5525 Manual

Wireless system that captures and transmits video frames to verify alarms

Advertisement

Quick Links

Silentron PhotoPir
Wireless system that captures and transmits
video frames to verify alarms
Part no. 3796
CCTV Wi-Fi
board
5525 PhotoPir
WIRELESS IR MOTION DETECTOR WITH BUILT IN CAMERA
(compatible with control panels part no. 5500 Silenya HT GSM Top supplied with part no. 3796 board).
EC Declaration of conformity: Silentron Spa declares under its sole responsibility that the products described in this manual comply with the requirements set
out by the following Directives and relevant Standards and/or technical specifications:
1) 1999/5/EC Directive dated 9 March 1999 - R&TTE - (Italian Legislative Decree No. 269 dated May 9, 2001) regarding radio and telecommunications terminal
equipment and the mutual recognition of their conformity. The following Standards and/or technical specifications have been applied:
- LVD and health protection (art. 3(1)(a)): EN 60950-1 (2006-04), EN 50371 (2002-03)
- EMC (art. 3(1)(b)): EN 301 489-1 V1.8.1 (2008-04), EN 301 489-3 V1.4.1 (2002-08), EN 301 489-7 V1.3.1 (2005-11)
- Radio Spectrum (art. 3(2)): EN 300 220-1 V2.1.1 (2006-04), EN 300 220-2 V2.1.2 (2007-06)
In compliance with Annex 4 of aforementioned Directive, this is a Class 2 product and can therefore be placed in the market and put into service without
restrictions.
2) EC 2004/108 Directive dated December 15, 2004 on the harmonisation of the laws of the Member States relating to electromagnetic compatibility. The
following Standards and/or technical specifications have been applied: EN 50130-4 (1995-12) + A1 (1998-04) + A2 (2003-01) - EN 55024 (1998-09) +A1 (2001-10)
+ A2 (2003-01) - EN 301489-1 V1.8.1 (2008-04) - EN 301489-3 V. 1.4.1 (2002-08) - EN 301489-7 V1.3.1 (2005-11).
3) EC 2006/95 Directive dated December 12, 2006 on the harmonisation of the laws of the Member States relating to electrical equipment designed for use
within certain voltage limits. The EN 60950-1 (2006-049) Standard has been applied.
4) Electronic alarm systems: Standard EN 50130-5; EN 50131-1 EN; EN 50131-2-2 (only for PIR section); EN 50069-1; EN 60529.
Safety Level: 1; Environmental class II.
TVCC 3796 CCTV BOARD is compatible only with 5500 Silenya HT GSM Top control panels.
EC Declaration of Conformity: this equipment operates with a 12Vcc power supply and it is one of the components forming an electronic alarm system that is
controlled by the above stated state-of-the-art control panel (FW 3015T). This unit cannot therefore be used without the aforementioned device although it
complies with the following standards:
1) EC 2004/108 Directive dated December 15, 2004 regarding electromagnetic compatibility. The following Standards and/or technical specifications have been
applied: EN 50130-4 (1995-12) + A1 (1998-04) + A2 (2003-01) - EN 55022:2006-09 +A1:2007-10- EN 301489-1 V1.8.1 (2008-04) - EN 301489-3 V. 1.4.1 (2002-08) -
EN 301489-7 V1.3.1 (2005-11).
2) CE Directive 2006/95 dated December 12, 2006: EN 60950-1 (2006-049) Standard has been applied.
Warning: the herein described equipment must be installed and commissioned by qualified technicians in compliance with current regulations taking care not to
partially or totally obstruct the device's field of sight and carefully checking transmission ranges.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PhotoPir 5525 and is the answer not in the manual?

Questions and answers

Summary of Contents for SILENTRON PhotoPir 5525

  • Page 1 (compatible with control panels part no. 5500 Silenya HT GSM Top supplied with part no. 3796 board). EC Declaration of conformity: Silentron Spa declares under its sole responsibility that the products described in this manual comply with the requirements set out by the following Directives and relevant Standards and/or technical specifications: 1) 1999/5/EC Directive dated 9 March 1999 - R&TTE - (Italian Legislative Decree No.
  • Page 2 5525 PhotoPir Overview: PhotoPir is an intrusion detector with a built-in camera. When the device is enabled, it reports alarm condition to the control panel while it captures and sends it pictures of the area. The wireless detector is battery operated, but it can also be mains powered using its special power supply unit (see specifications). When mains powered, batteries are disconnected and are used only in the event of power failure.
  • Page 3 Setting the detector in the system (compatible with control panels Silentron Silenya HT GSM Top using 3015T firmware and later versions) a) Set control panel in detector learning mode by selecting the appropriate options among the ones listed on the display.
  • Page 4 Caution! The device’s TEST mode is permanently enabled when the front cover of the device is open. Enabling camera's test mode: you must use a PC connected with special cable part no. 5997 and fitted with Silentron SW Box 3096 S08 or later software versions to check the quality of video frames captured by the camera .
  • Page 5 1. Overview and Operation The CCTV board captures images from the 5525 PhotoPir Silentron detector (up to 4 units) via Wi-Fi and transfers then to the control panel (firmware was especially enhanced for this purpose) over a serial connection. Captured video frames are transmitted as MMS/e-mails to preset telephone numbers stored in the control panel's phone book during the following events: a) at any time that the user requests images to be sent by transmitting the appropriate SMS;...
  • Page 6 Configuring MMS/EMAIL: go to MMS/MAIL menu to display the following setup fields. Confirm  Homepage for Italian WAP version 1.2.1/2.0 MMS Services. Italy: TIM/Vodafone/Wind SIM card settings are automatically entered. Proxy server - Italy: TIM/Vodafone/Wind SIM card settings are automatically entered. Proxy port - Italy: TIM/Vodafone/Wind SIM card settings are automatically entered.

Table of Contents