Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for A&L Furniture Poly Deep Seating Mission Swing
Summary of Contents for A&L Furniture Poly Deep Seating Mission Swing
- Page 1 Assembly Instructions Poly Deep Seating Mission Swing Furniture Co. Thank you for choosing We hope that this piece brings you many years of enjoyment! For help with assembling your furniture, or if you have missing hardware, please email us at...
- Page 2 PARTS (included) HARDWARE (included) ¼” x 2¾” Bolt (12) Headboard Assembly (2) 2” Screws (38) Back Assembly (1) Eyebolt (4) Side Rail (1) Allen Wrench (1) Mattress Board (5 or 8) Square Drive Bit (1) (Depends on length of swing) Rope (4) Cushion Support Strip (1) Only included if you ordered full seat &...
- Page 3 STEP 4 Screw the eyebolts into the headboards towards the top. (See photos 7 & 8.) You will need to do this at the front and back of the bed. Screw them in as tight as you can. photo 7 photo 8 STEP 5 Thread the end of one of the ropes through each eyebolt from the top.
- Page 4 The rope can also be adjusted to make the swing hang a little higher or lower. (See series of photos below.) Note: You will receive the ropes adjusted short in length. The photos show the ropes being adjusted long in length.
- Page 5 STEP 6 The cushion support strip will be included with your swing only if you have full cushions on the same order with your swing. If you have the support strip, you will need to fasten it to the inside of the back assembly. (See photo 14.) There will be predrilled holes in some of the slats on the back of the swing and also in the headboard.
Need help?
Do you have a question about the Poly Deep Seating Mission Swing and is the answer not in the manual?
Questions and answers