Yamaha MT10SPN Owner's Manual page 90

Periodic maintenance and adjustment
1
2
1 1
3
4
5
1. Coolant reservoir cover A
2. Radiator fin
6
6. Remove the bolt, and then remove
the coolant reservoir cover B.
7
8
9
1 1 1
10
11
12
1. Bolt
2. Coolant reservoir cover B
13
7. Remove the coolant reservoir cap.
WARNING! Remove only the
coolant reservoir cap. Never at-
tempt to remove the radiator
2 2
cap
hot.
1 1 1
1. Coolant reservoir cap
8. Add coolant to the maximum level
mark. NOTICE: If coolant is not
available, use distilled water or
soft tap water instead. Do not
2 2
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the cooling system will not
be protected against frost and
corrosion. If water has been
added to the coolant, have a
when the engine
[EWA15162]
1
8-15
Yamaha dealer check the anti-
freeze content of the coolant as
is soon as possible, otherwise the
effectiveness of the coolant will
be reduced.
[ECA10473]
9. Install the coolant reservoir cap.
10. Place the coolant reservoir cover B
in its original position, and then
tighten the bolts to the specified
torque.
Tightening torque:
Coolant reservoir cover bolt:
4.3 N·m (0.43 kgf·m, 3.2 lb·ft)
11. Place the coolant reservoir cover A
in its original position, and then in-
stall the quick fastener.
TIP
The quick fastener is installed by push-
ing out the center pin, inserting the fas-
tener into the cover, and then by
pushing the center pin flush with the
fastener head.