Yamaha BOLT 2019 Owner's Manual page 55

TIP
An oil filter wrench is available at a
Yamaha dealer.
5. Apply a thin coat of clean engine
oil to the O-ring of the new oil filter
cartridge.
1. O-ring
TIP
Make sure that the O-ring is properly
seated.
6. Install the new oil filter cartridge
with an oil filter wrench, and then
tighten it to the specified torque
with a torque wrench.
Periodic maintenance and adjustment
2
1. Torque wrench
2. Oil filter cartridge
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 32 lb·ft)
8. Refill with the specified amount of
the recommended engine oil.
7-13
Recommended engine oil:
See page 9-1.
Oil quantity:
Oil change:
3.70 L (3.91 US qt, 3.26 Imp.qt)
With oil filter removal:
1
4.00 L (4.23 US qt, 3.52 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Make sure that no foreign mate-
rial enters the crankcase.
9. Check the O-ring for damage, and
replace it if necessary.
ECA11621
7