Yamaha BOLT 2019 Owner's Manual page 23

Push the "SELECT" switch to change
the display between the odometer
"ODO", tripmeters 1 and 2 "TRIP 1"
and "TRIP 2", and the clock in the fol-
lowing order:
ODO → TRIP 1 → TRIP 2 → clock →
ODO
If the fuel level warning light comes on
(see page 4-1), the display will change
to the fuel reserve tripmeter "TRIP F"
and start counting the distance trav-
eled from that point. In this case, push
the "SELECT" switch to change the
display in the following order:
TRIP F → TRIP 1 → TRIP 2 → clock →
ODO → TRIP F
To reset a tripmeter, use the "SELECT"
switch to change the display to the de-
sired tripmeter and then push the "RE-
SET" switch for one second.
The fuel reserve tripmeter can be reset
manually, or after refueling and travel-
ing 5 km (3 mi) it will reset automatically
and disappear from the display.
Instrument and control functions
To set the clock
1. Clock
1. Push the "SELECT" and "RESET"
switches for three seconds. The
hour digits will start flashing.
2. Use the "SELECT" switch to set
the hours.
3. Push the "RESET" switch. The
minute digits will start flashing.
4. Use the "SELECT" switch to set
the minutes.
5. Push the "RESET" switch for two
seconds to confirm settings and
start the clock.
4-4
Self-diagnosis device
1
1. Error code display
2. Engine trouble warning light "
This model is equipped with a self-di-
agnosis device for various electrical
circuits.
If a problem is detected in any of those
circuits, the engine trouble warning
light will come on and the display will
indicate an error code.
If the display indicates any error codes,
note the code number and have a
Yamaha dealer check the vehicle.
1
2
4
"